Interlogix xGenConnect NXG-4 Installation And Programming Manual page 166

Zone Number. Zone Name
•
In alarm: This zone has triggered a system alarm condition.
•
Is bypassed: This zone is bypassed (inhibited) and will not activate an alarm.
•
Chime is set: This zone is part of the chime group.
•
Is not secure: This zone is not closed.
•
Fire alarm: This zone has triggered a fire alarm.
•
Tamper: This zone has triggered a tamper alarm.
•
Trouble fault: This zone has an open circuit.
•
Loss of wireless supervision: This zone is a wireless device and has lost its
communication link with the control panel. Check the zone is within range of
the panel and has sufficient battery.
•
Low battery: This zone is a wireless device and needs a battery replacement.
154 xGenConnect Installation and Programming Guide