file:///E:/PV-9661_PV-9662/SVC/s0401150000.html
a. Do not attempt to lift the component off the board until the component is completely
disconnected from the board by a twisting action.
b. Be careful not to break the copper foil on the printed circuit board.
3. Installing the leadless component
A. Presolder the contact points on the circuit board.
4. Press the part downward with tweezers and solder both electrodes as shown below.
Note:
Do not glue the replacement leadless component to the circuit board.
TOP PREVIOUS NEXT
file:///E:/PV-9661_PV-9662/SVC/s0401150000.html (2 z 2) [2006-01-28 11:09:17]
Fig. 8-1
Fig. 8-2
Fig. 8-3