Table of Contents
Advertisement
PV-9661 / PV-9662
5.2.14. T Loading Arm Unit and S Loading
Arm Unit
5.2.14.1. Disassembly Procedure
1. Remove the T Loading Arm Unit by pulling it up while
releasing Locking Tab (K).
2. Pull up on the S Loading Arm Unit.
5.2.14.2. Reassembly Notes
1. Alignment of Loading Rack Unit, T Loading Arm Unit,
and S Loading Arm Unit
a. Slide the Loading Rack Unit so that the holes on it and
the holes on the chassis line up properly.
b. Install the S Loading Arm Unit onto the Chassis.
c. Install the T Loading Arm Unit so that the triangle-
shaped indent is aligned with the arrow on the S
Loading Arm Unit as shown. Confirm that each hole on
the T Loading Arm Unit, Chassis, and Loading Rack
Unit are through holes.
Fig. J13-1
Fig. J13-2
5.2.15. Center Clutch Unit, Changing Gear
Spring, Changing Gear, Changing
Lever-B, and Idler Arm Unit
5.2.15.1. Disassembly Procedure
1. Remove Cut Washer (B). Then remove the Center Clutch
Unit, Changing Gear Spring, and Changing Gear.
2. Remove Changing Lever -B so that the 2 Mounting Holes
clear Mounting Pins.
3. Pull up on the Idler Arm Unit.
5.2.15.2. Reassembly Notes
1. Installation of Center Clutch Unit
a. Fit the Center Clutch Unit into the Changing Gear as
shown.
2. Cut Washer (B) is not reusable. Install a new one.
32
Fig. J14-1
Fig. J14-2
Advertisement
Table of Contents
