Fig. J8-1
5.2.9.2.
Reassembly Notes
1. How to distinguish between S Reel Table and T Reel
Table
Fig. J8-2
2. Cut Washer (A) is not reusable. Install a new one.
5.2.10. Full Erase Head, Tension Arm Unit,
S Spring Arm, and S Reel Table
5.2.10.1. Disassembly Procedure
1. Turn the Full Erase Head fully counterclockwise while
releasing Locking Tab (F) as shown. Then remove it.
2. Unhook Spring (A).
3. Remove the Tension Arm Unit by pulling it up while
releasing 2 Locking Tabs (G).
4. Remove the S Spring Arm while releasing Locking Tab (H).
5. Pull up on the S Reel Table.
5.2.10.2. Reassembly Notes
1. Confirmation/Adjustment of Tension Arm Unit
a. When installing Tension Arm Unit and S Spring Arm,
confirm "a," "b," "c," and "d" portion are in the proper
position as shown.
b. After
installing,
ADJUSTMENT" procedures.
5.2.11. S Brake Arm Unit, Main Lever
Guide, Loading Post Base -S, and
Loading Post Base -T Unit
5.2.11.1. Disassembly Procedure
1. Remove the S Brake Arm Unit while releasing 2 Locking
Tabs (I).
2. Remove the Main Lever Guide while releasing Locking Tab
(J).
3. Slide the Loading Post Base -S and T Units to the end of
the guide slots to remove.
29
Fig. J9-1
Fig. J9-2
perform
the
"TENSION
PV-9661 / PV-9662
POST