file:///E:/PV-9661_PV-9662/SVC/s0502060200.html
5.2.6.2 Reassembly Notes
TOP PREVIOUS NEXT
1.
Alignment of Main Cam Gear, Drive Rack Arm, and Main Lever Drive Arm
A. Confirm that the hole (C) on the Main Lever Drive Arm is aligned with the hole on
chassis (Through hole (C)) as shown.
B. Install the Drive Rack Arm so that the hole (A) is aligned with the hole on chassis
(Through hole (A)) as shown.
C. Install the Main Cam Gear so that the 2 holes (B) marked "E" are aligned with the hole
on chassis (Through hole (B)) as shown. ("E" indicates the
2.
Holes on Main Cam Gear
A. The holes on Main Cam Gear should be aligned with the hole on chassis in each mode
(Through hole) as shown.
Main Cam Gear Kit
●
file:///E:/PV-9661_PV-9662/SVC/s0502060200.html (1 z 2) [2006-01-28 11:10:00]
Fig. J5-3
Fig. J5-4
EJECT
position.)