Table of Contents
Advertisement
PV-9661 / PV-9662
5.2.7.
Main Lever
5.2.7.1.
Disassembly Procedure
1. Release 2 Locking Tabs (C) and Locking Tab (D). Then,
remove the Main Lever.
5.2.7.2.
Reassembly Notes
1. Installation/Alignment of Main Lever
a. Make sure that the 2 holes of Loading Rack Unit are
aligned with the holes on chassis (Through holes).
b. Turn the P5 Arm Unit to the Capstan Rotor Unit Shaft
side.
c. Turn the T Brake Unit to the T Reel Table side.
d. Position the Main Lever so that the Loading Rack Unit
Pin fits in the niche of Main Lever.
Confirm that pins and bosses are in the position and
that the hole of Main Lever is aligned with the hole on
chassis (Through hole) as shown. Then, install the Main
Lever.
e. Push down the Locking Tabs (C) to set in the groove of
Main Lever Guide.
Fig. J6-1
Fig. J6-2
5.2.8.
P5 Arm Unit and Main Lever Drive
Arm
5.2.8.1.
Disassembly Procedure
1. Pull up on the P5 Arm Unit.
2. Turn the Main Lever Drive Arm fully counterclockwise as
shown.
3. Pull up on the Main Lever Drive Arm.
5.2.8.2.
Reassembly Notes
1. Alignment of Main Lever Drive Arm
a. Install the Main Lever Drive Arm so that the hole (C) is
aligned with the hole on the chassis Through hole (C))
as shown.
5.2.9.
T Brake Unit, Changing Lever A,
and T Reel Table
5.2.9.1.
Disassembly Procedure
1. Remove the T Brake Unit while releasing Locking Tab (E)
located under the chassis.
2. Remove Cut Washer (A). Then, pull up on the Changing
Lever A and remove.
3. Pull up on the T Reel Table.
28
Fig. J7-1
Fig. J7-2
Advertisement
Table of Contents
