Table of Contents
Advertisement
PV-9661 / PV-9662
4.2.
IC, TRANSISTOR AND CHIP PART INFORMATION
4.2.1.
HOW TO READ THE
IDENTIFICATION MARK OF CHIP
COMPONENTS.
4.2.2.
HOW TO READ THE VALUES OF
THE CYLINDRICAL TYPE CHIP
COMPONENTS.
The widest color band must be read first for value.
1. RESISTOR
There are two types (ERD10LLJ... and ERD10TLJ...) of
chip parts.
a. ERD10LLJ : Refer to above type.
b. ERD10TLJ : The narrow color band must be read first
for value.
If this part is included in the parts list, be sure that the color
band is read properly when servicing.
2. CAPACITOR
Because of the width of the color bands, the reading
direction cannot be specified. However, the color band can
be read on either side. Be sure to confirm the value using
the schematic diagram.
CAUTION :
Once chip parts are removed, they must not be reused.
Always use a new part when installing a chip part.
18
Advertisement
Table of Contents
