Table of Contents
Advertisement
file:///E:/PV-9661_PV-9662/SVC/s0503010200.html
5.3.1.2 Reassembly Notes
TOP PREVIOUS NEXT
1.
Alignment of Wiper Arm Unit and Drive Rack Unit
A. Slide the Drive Rack Unit to the far right as indicated by the arrow.
B. Install the Wiper Arm Unit so that the hole on the Wiper Arm Unit is aligned with the
hole on the Drive Rack Unit.
2.
Installation of Holder Unit
A. Turn the Wiper Arm Unit so that the grooves on each end are aligned with the each
groove on Side Plate L and R.
B. Insert Holder Unit boss (A) and (B) into the grooves (See Fig. K1-1 on previous page).
C. Finally, in the EJECT Position, confirm that the protrudence on the Wiper Arm Unit is
aligned with the indentation on the Drive Rack Unit.
file:///E:/PV-9661_PV-9662/SVC/s0503010200.html (1 z 2) [2006-01-28 11:10:40]
Fig. K1-2
Fig. K1-3
Advertisement
Table of Contents
