Table of Contents
Advertisement
Fig. J5-1
Note:
When removing the Main Cam Push Nut, press the Main
Cam Gear to make space between the Main Cam Push Nut
and Bottom of Chassis. Then, remove the Main Cam Push
Nut using a screwdriver etc.
Fig. J5-2
5.2.6.2.
Reassembly Notes
1. Alignment of Main Cam Gear, Drive Rack Arm, and
Main Lever Drive Arm
a. Confirm that the hole (C) on the Main Lever Drive Arm
is aligned with the hole on chassis (Through hole (C)) as
shown.
b. Install the Drive Rack Arm so that the hole (A) is aligned
with the hole on chassis (Through hole (A)) as shown.
c. Install the Main Cam Gear so that the 2 holes (B)
marked "E" are aligned with the hole on chassis
(Through hole (B)) as shown. ("E" indicates the EJECT
position.)
2. Holes on Main Cam Gear
a. The holes on Main Cam Gear should be aligned with the
hole on chassis in each mode (Through hole) as shown.
3. Main Cam Gear Kit
a. Main Cam Gear is supplied as a Main Cam Gear Kit
only (Kit No. VVGS0008).
Main Cam Gear Kit consists of a Main Cam Gear and a
Main Cam Push Nut.
However, Main Cam Push Nut is available separately as
a replacement part.
4. Installation of Main Cam Gear and Main Cam Push Nut
a. Position the chassis upside down and place a Support
under the Main Cam Gear.
Install the Main Cam Push Nut with Needlenose Pliers
etc. so that it is flush with the chassis.
There may be some slight scratches on the Shaft of
Main Cam Gear, when removing the Main Cam Gear. In
case that the Main Cam Gear can be installed securely
without tottering, it is fine to use the one. If any tottering,
install all new parts.
5. The Main Cam Push Nut is not reusable. Install a new one.
6. Make sure to hook Spring (A) of the Cassette Up Ass'y to
the Drive Rack Arm. Refer to "Cassette Up Ass'y" in
"Disassembly/Assembly Procedures of Cabinet."
27
PV-9661 / PV-9662
Fig. J5-3
Fig. J5-4
Fig. J5-5
Advertisement
Table of Contents
