Table of Contents
Advertisement
PV-9661 / PV-9662
5.2.11.2. Reassembly Notes
1. Adjustment of Loading Post Base -S Unit and Loading
Post Base -T Unit
a. After installing, perform the "P2 AND P3 POST HEIGHT
ADJUSTMENT
procedures
and
ADJUSTMENT (FINAL ADJUSTMENT)" procedures.
5.2.12. Capstan Rotor Unit, Capstan
Holder Unit, and SS Brake Arm
Unit
5.2.12.1. Disassembly Procedure
1. Remove the Capstan Belt.
2. Cut the Stopper with a cutter to remove.
3. Pull up on the Capstan Rotor Unit.
4. Remove 3 Screws (B). Then remove the Capstan Holder
Unit.
5. Unhook Spring (B).
6. Turn the SS Brake Arm Unit so that the Tab (A) lines up
with the niche. Then, remove the SS Brake Arm Unit.
Fig. J10
(PRELIMINARY
ADJUSTMENT)"
"TAPE
INTERCHANGEABILITY
5.2.12.2. Reassembly Notes
1. Installation of Capstan Rotor Unit
a. Insert the Capstan Rotor Unit Shaft into the hole of the
Capstan Holder Unit.
b. Place a support under the Capstan Rotor Unit shaft.
Install the Stopper. Be careful not to scratch the shaft or
Capstan Holder Unit.
c. Remove the support. Press the top end of the shaft
down so that the Stopper is properly positioned.
You should be able to move the shaft up and down
slightly when properly positioned.
2. Capstan Rotor Kit
a. Capstan Rotor Unit, Capstan Holder Unit, and Stopper
are supplied as a Capstan Rotor Kit only. (Kit No.
VXPS0382K2) They are not reusable. Install all new
parts.
b. Because even invisible scratches on the Capstan Rotor
Unit shaft and the Capstan Holder Unit, made when
cutting the Stopper, could cause tape path instability.
30
Fig. J11-1
Fig. J11-2
Advertisement
Table of Contents
