Table of Contents
Advertisement
file:///E:/PV-9661_PV-9662/SVC/s0502060200.html
A. Main Cam Gear is supplied as a Main Cam Gear Kit only (Kit No. VVGS0008).
Main Cam Gear Kit consists of a Main Cam Gear and a Main Cam Push Nut.
However, Main Cam Push Nut is available separately as a replacement part.
Installation of Main Cam Gear and Main Cam Push Nut
●
A. Position the chassis upside down and place a Support under the Main Cam Gear.
Install the Main Cam Push Nut with Needlenose Pliers etc. so that it is flush with the chassis.
There may be some slight scratches on the Shaft of Main Cam Gear, when removing the Main
Cam Gear. In case that the Main Cam Gear can be installed securely without tottering, it is fine
to use the one. If any tottering, install all new parts.
The Main Cam Push Nut is not reusable. Install a new one.
●
Make sure to hook Spring (A) of the Cassette Up Ass´y to the Drive Rack Arm. Refer to "
●
Up Ass´y
" in "Disassembly/Assembly Procedures of Cabinet."
TOP PREVIOUS NEXT
file:///E:/PV-9661_PV-9662/SVC/s0502060200.html (2 z 2) [2006-01-28 11:10:00]
Fig. J5-5
Cassette
Advertisement
Table of Contents
