Lexmark Optra C710 Setup Manual page 93

Note:
"X" designates which
option slot in the printer is being
used. For example, if you install
the MarkNet card in option slot
2, the operator panel selection
would read:
Network Option 2
Note:
The workstation and
the printer must be on the same
subnet.
the printer operator panel, static ARP and telnet,
RARP and telnet, BOOTP, or MarkVision or other
Lexmark utility. Instructions for three of these meth-
ods follow.
Printer operator panel
A simple way to set the IP address, netmask and gateway
inside the print server is to use the operator panel. You
need to be standing at the printer to use this method.
1
On the operator panel, choose
Network Option X
IP Address
correct menu item, and then press
2
.
When the current IP address is displayed, use the
buttons to change the address. (Hint: Pressing
advances you to the next segment in the
Select
address. Pressing
one.
<Menu
3
When you finish setting the IP address, press
until the word
Select
new network setup page to verify the parameters
are set as you intended.
Static ARP and telnet
You can use this method from any Windows, OS/2, or
UNIX workstation. You need to know the physical
address of the print server to use this method.
1
Find the physical address (UAA) of the print
server (for example, 00200022012F) on the network
setup page you printed earlier. If you have an
Ethernet network, use the number in the right
column (canonical). If you have a Token-Ring
network, use the number in the left column
(MSB).
,
Network Option X Setup
. (Hint: Press
Menu>
increases the number by
Menu>
decreases the number by one.)
appears briefly. Print a
SAVED
Configuring and printing
,
Network Menu
, ,
TCP/IP Set
until you see the
.)
Select
89