Lexmark Optra C710 Setup Manual page 47

Note:
The hinge point of the
access door is at the bottom of
the rear duplex assembly. The
door opens away from the rear
of the printer.
Rear duplex assembly
Alignment pin
Alignment pins
Alignment pin covers
2
Access door
3
Access door
hinge point
4
Align the holes in the support brackets and the
holes on the bottom of the rear duplex assembly
with the pins on the rear of the output bin and the
pins on the duplex unit base.
Lower the rear duplex assembly onto the pins and
connector of the duplex unit base until the rear
duplex assembly snaps into place.
Place the previously removed alignment pin cov-
ers over the support brackets as shown.
The covers snap into place when aligned and
pressed down.
If the alignment pin covers are difficult to install,
make sure the rear duplex assembly is fully seated
and the brackets are properly aligned on the pins.
Repeat steps 2 and 3 if necessary.
Installing the rear assembly
43