Lexmark Optra C710 Setup Manual page 70

Note:
Connect only one net-
work cable even if the internal
print server (sometimes called
internal network adapter) has
more than one network port.
Caution!
When connecting a
cable to the printer from another
powered component make sure
you unplug that component
before connecting any cables to
the printer.
Standard parallel
cable and connector
Optional cable and
connector
Note:
If you are installing a
fax modem or infrared adapter,
do not connect the power cord
or turn on the printer at this
time.
66
Cable information
To attach a cable to your printer:
1
Make sure the printer power is off (O) and the
power cord is unplugged.
2
At the left rear of printer, locate the parallel, serial,
or network cable connector.
One parallel connector is standard. Depending on
the options you have installed, additional parallel,
serial and network connectors may be available.
3
Connect the appropriate cable.
Use the table below
to locate your next step
Do you need to...
"Connect an external fax modem", see page 67
"Connect an infrared adapter", see page 70
"Continue with printer setup", see step 4
4
Plug the power cord into a properly grounded
electrical outlet.
5
Place the printer power switch to on (I).
Proceed to Step 10: "Load the
paper tray" on page 73