Lexmark Optra C710 Setup Manual page 48

Installing the
top assembly
Alignment pins and connector
44
Installing the top assembly
Pad
1
Place the bridge block onto the forward pad in the
output bin as shown.
The hinged side of the bridge block must be toward
the rear of the printer for correct installation.
The bridge block may be squeezed together to make
placement on the pad easier.
The bridge block has a small magnetic pad on the
bottom that must rest on the metal pad in the front
of the output bin.
2
Align the pins and connector of the top duplex
assembly with the holes and connector on the rear
duplex assembly.
3
Lower the pins of the top duplex assembly into the
holes of the rear duplex assembly until the top
duplex assembly snaps into place.