Lexmark Optra C710 Setup Manual page 12

Warning!
The EMI shield must
be replaced before operating the
printer.
8
Removing the rear cover and EMI shield
2
Loosen the four screws on the rear cover as shown.
The screws on the rear cover are captive and will
remain on the cover.
3
Remove the rear cover and place it to the side.
4
Loosen the six screws on the EMI shield as shown.
The screws on the EMI shield are captive and will
remain on the shield.
5
Lift and remove the EMI shield and place it to the
side.
Use the table below to locate
the steps for your options
See...
"Installing memory" on page 9
"Attaching a hard disk" on page 20
"Installing adapters" on page 22