Configure Remote Logging/Syslog Server - TRENDnet TPE-3012LS User Manual

TRENDnet User's Guide

Configure Remote Logging/Syslog Server

Diagnostics > Logging > Remote Server
1. Log into your switch management page (see
on page 11).
2. Click on Diagnostics, click on Logging, and click on Remote Server.
3. Click Add and review the settings below.
Item Description
Server The IP address of the remote logging server.
Address
Server The port number of the remote logging server.
Ports
The facility of the logging messages. It can be one of the
Facility
following values: local0,local1, local2, local3, local4, local5,
local6, and local7.
The minimum severity.
•
Emergence: System is not usable.
•
Alert: Immediate action is needed.
Severity
•
Critical: System is in the critical condition.
•
Error: System is in error condition
•
Warning: System warning has occurred
has occurred.
•
•
Notice: System is functioning properly, but a system notice
Informational: Device information.
•
Debug: Provides detailed information about an event.
© Copyright 2020 TRENDnet. All Rights Reserved.
"Access your switch management page"
4. Click Apply.
5. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
6. Click OK.
TPE-3012LS / TPE-3018LS
143