Table of Contents
Advertisement
TRENDnet User's Guide
View and setup your switch logging
System > System Log
The system log is designed to monitor the operation the switch by recording the event
messages it generates during normal operation. These events may provide vital
information about system activity that can help in the identification and solutions of
system problems.
1. Log into your switch management page (see
on page 7).
2. Click on System, and click on System Log.
3. Review the settings. Click Apply to save changes.
Time Stamp
o
Enable - Each event message recorded in the log will have a time
stamp.
o
Disable - No time stamp will be included with the event messages.
Message Buffered Size - Enter the message buffer size. (Range: 1-200)
Syslog Status - Allows you to send device logging to an external log (Syslog)
server for troubleshooting or monitoring.
o
Enable – Enable syslog and in the Syslog Server IP section, enter the
IPv4 or IPv6 address of the external syslog server to send logging.
o
Disable – Disable syslog functionality.
Facility - Click the drop-down list and which facility to store the logging.
(Options: local0 – local7)
Note: You can define the facility to store logging on your external syslog server.
This helps to ensure you have separate logging sections for different devices.
Logging Level – Click the drop-down list to select what level of event messages
that will be logged.
1 Alert - Action must be taken immediately.
2 Critical - Critical conditions are displayed.
3 Warning - Warning conditions are displayed.
4 Info - Informational messages are displayed.
© Copyright 2017 TRENDnet. All Rights Reserved.
"Access your switch management
page"
4. In the left hand panel, click Tools, click on Configuration, and click Save.
5. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-204WS
18
Advertisement
Table of Contents
