Configure Radius Network Authentication Settings - TRENDnet TPE-3012LS User Manual

TRENDnet User's Guide

Configure RADIUS network authentication settings

Security > Authentication Manager > Property
This section allows the configuration of ports to require authorization/authentication,
guest VLAN assignment for unauthenticated users, and authentication methods
required on network access ports.
1. Log into your switch management page (see
on page 11).
2. Click on Security, click on Authentication Manager, and click on Property.
3. Review the settings. Click Apply to save the settings.
Configure the following parameters as required:
•
Authentication Type: Check the 802.1X option to enable 802.1X.
•
Guest VLAN: Check the Enable option and click the drop-down list to select the
guest VLAN assignment for unauthorized/authenticated users.
Note: VLANs must be created under the VLAN > VLAN > Create VLAN section to
be available in the drop-down list.
•
MAC-Based User ID Format: Click the drop-down list to select the MAC User
Name/Password ID format used for port authentication.
To configure the ports to set/require for 802.1X authentication, select the port or ports
in the list and click Edit.
© Copyright 2020 TRENDnet. All Rights Reserved.
"Access your switch management page"
•
Port: Displays the specified port or ports to configure.
•
Authentication Type: Check the 802.1X to require authentication for the
selected port or ports.
•
Host Mode: Select the host mode.
o
Multiple Authentication: Using this mode, all 802.1X clients must
authenticate individually for network access.
o
Multiple Hosts: In this mode, only a single 802.1X client must be
authenticated, all clients afterwards will also be provided network
access.
o
Single Host: In this mode, only a single 802.1X client can be
authenticated and provide network access at any given time. The
client must logout or deauthenticate before another 802.1X client can
be allowed network access.
•
Method: In the Available Method list, select the authentication methods
allowed for the authentication on the selected port or ports. You can use the
arrow buttons to add and remove to the Selected Method list.
Note: Multiple methods can be selected at the same time by holding the Shift or
Ctrl key.
•
Guest VLAN: Check the Enable option to allow unauthorized users to be
assigned to the guest VLAN assignment. The Guest VLAN ID can be assigned in
the global settings.
Note: VLANs must be created under the VLAN > VLAN > Create VLAN section to
be available in the drop-down list.
TPE-3012LS / TPE-3018LS
105