Configure Ipv4 Ace - TRENDnet TPE-3012LS User Manual

TRENDnet User's Guide

Configure IPv4 ACE

ACL > IPv4 ACE
This section allows users to configure access control entries/policies for the IPv4 ACLs
defined and filtered based on IPv4 address.
1. Log into your switch management page (see
on page 11).
2. Click on ACL and click on IPv4 ACE.
3. Review the settings below.
Item Description
ACL Name Display the ACL name to which an ACE is being added.
Specify the sequence of the ACE. ACEs with higher sequence
are processed first (1 is the highest sequence). Only
Sequence
available on Add dialog.
Select the action for a match.
●
Permit: Forward packets that meet the ACE criteria.
●
Action
Deny: Drop packets that meet the ACE criteria.
Shutdown: Drop packets that meet the ACE criteria, and
disable the port from where the packets were received.
Such ports can be reactivated from the Port Settings page.
© Copyright 2020 TRENDnet. All Rights Reserved.
"Access your switch management page"
Select the type of protocol for a match.
●
Any (IP): All IP protocols are acceptable.
●
Select from list: Select one of the following protocols
from the drop-down list.
Protocol
(ICMP/IPinIP/TCP/EGP/IGP/UDP/HMP/RDP/IPV6/IPV6:R
OUT/IPV6:FRAG/ RSVP/IPV6:ICMP/OSPF/PIM/L2TP)
●
Protocol ID to match: Enter the protocol ID.
Select the type for source IP address.
●
Any: All source addresses are acceptable.
●
Source IP
User Defined: Only a source address or a range of
source addresses which users define are acceptable.
Enter the source IP address value and mask to which
will be matched.
Select the type for destination IP address.
●
Any: All destination addresses are acceptable.
●
Destination
User Defined: Only a destination address or a range of
IP
destination addresses which users define are
acceptable. Enter the destination IP address value and
mask to which will be matched.
TPE-3012LS / TPE-3018LS
131