TRENDnet User's Guide
Diagnostics
This section provides diagnostics tools for troubleshooting.
Configure Logging
Diagnostics > Logging > Property
1. Log into your switch management page (see
on page 11).
2. Click on Diagnostics, click on Logging, and click on Property.
3. Review the settings below.
Item
Description
Enable/Disable the global logging services. When the logging
service is enabled, logging configuration of each destination
State
rule can be individually configured. If the logging service is
disabled, no messages will be sent to these destinations.
Console Logging
State
Enable/Disable the console logging service
Minimum
The minimum severity for the console logging.
Severity
RAM Logging
State
Enable/Disable the RAM logging service.
Minimum
The minimum severity for the RAM logging.
Severity
Flash Logging
State
Enable/Disable the flash logging service.
© Copyright 2020 TRENDnet. All Rights Reserved.
"Access your switch management
page"
The minimum severity for the flash loggin.
Minimum
Severity
4. Click Apply.
5. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
6. Click OK.
TPE-3012LS / TPE-3018LS
142