Add Multicast Router Ports - TRENDnet TPE-3012LS User Manual

TRENDnet User's Guide

Add multicast router ports

Multicast > General > Router Port
Static router ports can be specified for multicast traffic in this section.
1. Log into your switch management page (see
on page 11).
2. Click on Multicast, click on General, and click Router Port.
3. Click Add to add a new static muliticast address entry.
•
VLAN – In the Available VLAN list, select the VLAN IDs to assign the multicast
router ports. You can use the arrow
the Selected VLAN list.
Note: Multiple VLAN IDs can be selected at the same time by holding the Shift
or Ctrl key.
•
IP Version – Select the IP address version of the multicast static address, IPv4
or IPv6.
•
Port – In the Available Port list, select the static multicast router ports to
configure. You can use the arrow
Selected Port list.
Note: Multiple ports can be selected at the same time by holding the Shift or
Ctrl key.
© Copyright 2020 TRENDnet. All Rights Reserved.
"Access your switch management page"
buttons to add and remove to
buttons to add and remove to the
4. Click Apply.
5. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
6. Click OK.
TPE-3012LS / TPE-3018LS
92