Configuration Using Instrument Front Panel - Agilent Technologies InfinityLab 1290 Infinity II User Manual

3 LAN Configuration
TCP/IP Parameter Configuration

Configuration Using Instrument Front Panel

Configuration of the TCP/IP parameters via the front panel is the recommended
method for setting up the module's LAN interface. On-board configuration is only
possible during the module's start-up procedure.
1 Power on the detector, and press any front key when the following message is
If no key is pressed within 5 s, the ELSD will continue its start-up routine. The
NOTE
previously stored TCP/IP parameters will be used.
2 Select LAN using left/right arrow keys and press AZ/Stop to confirm.
3 Select either Static or DHCP (automatic) IP address assignment and press
4 If Dynamic IP address is selected, the instrument will try to obtain an IP
5 If Static IP address is selected, the instrument will display the stored static
The detector will use the default TCP/IP settings if no IP address has been
NOTE
programmed previously (see
6 To enter a new IP address, use the up/down arrow keys.
7 To enter a new Subnet Mask, use the up/down arrow keys.
8 To enter a new Gateway address, use the up/down arrow keys.
9 When all values are populated press AZ/Stop to accept.
If the IP address and Gateway combination are incompatible, the instrument will
NOTE
return an INVALID network setting message.
The MAC address and Host Names of the instrument are displayed on the LAN
NOTE
configuration screens for reference.
Agilent InfinityLab ELSD User Manual
displayed "Press a key to enter communication
AZ/Stop to confirm.
address from the network.
When successful, the detector will continue to the main menu screen.
TCP/IP settings.
The instrument will continue to the main menu screen to confirm that the
settings have been implemented.
Once the LAN settings are configured, they are stored in memory even after a
power cycle.
Table 8 on page 29).
setup".
30