Policy Health-Probe Tcp - Cisco Catalyst 6500 Series Command Reference Manual

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

policy health-probe tcp

To enter the TCP health probe configuration submode, use the policy health-probe command. In TCP
health probe configuration submode, you can define the TCP health probe policy that is applied.
Syntax Description policy-name
Defaults
The defaults are as follows:
•
•
•
•
•
Command Modes
Context subcommand mode
Command History Release
SSL Services Module
Release 3.1(1)
Usage Guidelines
Table 2-9
Table 2-2 TCP Health Probe Submode Command Descriptions
Syntax
interval seconds
failed-interval seconds
maximum-retry retries
OL-9105-01
policy health-probe tcp policy-name
failed-interval is 60 seconds.
interval is 30 seconds.
maximum-retry is 0.
open-timeout is 80 seconds.
port is the port of the server IP address that you configured in the SSL server proxy service.
Modification
Support for this command was introduced on the Catalyst 6500 series
SSL Services Module.
lists the commands that are available in TCP health probe policy configuration submode.
Description
(Optional) Allows you to set the interval between probes in seconds (from
the end of the previous probe to the beginning of the next probe) when the
server is healthy. The default is 30 seconds. The valid range is from 30 to
300 seconds.
(Optional) Allows you to set the time between health checks after the
service has been marked as failed. The default is 60 seconds. The valid
range is from 30 to 3600 seconds.
(Optional) Sets the number of failed probes that are allowed before
marking the service as failed. The default is 0 retries. The valid range is
from 1 to 5 retries.
TCP health probe policy name.
Catalyst 6500 Series Switch SSL Services Module Command Reference
policy health-probe tcp
2-31