Cisco Catalyst 6500 Series Command Reference Manual page 72

policy tcp
Usage Guidelines
After you define the TCP policy, you can associate the TCP policy with a proxy server using the
proxy-policy TCP configuration submode commands.
Each proxy-policy TCP configuration submode command is entered on its own line.
Table 2-5
Table 2-5 Proxy-policy TCP Configuration Submode Command Descriptions
Syntax
[no] buffer-share rx buffer-limit-in-bytes
[no] buffer-share tx buffer-limit-in-bytes
default
delayed-ack-threshold delay
delayed-ack-timeout timer
exit
forced-ack
help
[no] mss max-segment-size-in-bytes
[no] nagle
[no] timeout fin-wait timeout-in-seconds
[no] timeout inactivity timeout-in-seconds
[no] timeout syn timeout-in-seconds
Catalyst 6500 Series Switch SSL Services Module Command Reference
2-46
lists the commands that are available in proxy-policy TCP configuration submode.
Description
Allows you to configure the maximum size of the receive buffer share per
connection; valid values are from 8192 to 262144. Use the no form of this
command to return to the default setting.
Allows you to configure the maximum size of the transmit buffer share per
connection; valid values are from 8192 to 262144. Use the no form of this
command to return to the default setting.
Sets a command to its default settings.
Allows you to configure the delayed ACK threshold. The default is 2. The
valid range is from 1 to 10.
Allows you to configure the delayed ACK timeout. The default is 200
seconds. The valid range is from 50 to 500 seconds.
Exits from proxy-service configuration submode.
Allows you to enable the forced-ACK algorithm.
Provides a description of the interactive help system.
Allows you to configure the maximum segment size that the connection
identifies in the generated SYN packet; valid values are from 64 to 1460.
Use the no form of this command to return to the default setting.
Allows you to enable or disable the Nagle algorithm. Nagle is enabled by
default.
Allows you to configure the FIN wait timeout; valid values are from 75 to
600 seconds. Use the no form of this command to return to the default
setting.
Allows you to configure the inactivity timeout; valid values are from 0 to
960 seconds. This command allows you to set the aging timeout for an idle
connection and helps protect the connection resources. Use the no form of
this command to return to the default setting.
Allows you to configure the connection establishment timeout; valid values
are from 5 to 75 seconds. Use the no form of this command to return to the
default setting.
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
OL-9105-01