Configuring Health-Monitoring Diagnostics - Cisco Catalyst 9500 Manual

Configuring Health-Monitoring Diagnostics

Configuring Health-Monitoring Diagnostics
You can configure health-monitoring diagnostic testing on a device while it is connected to a live network.
You can configure the execution interval for each health-monitoring test, enable the device to generate a
syslog message because of a test failure, and enable a specific test.
Use the no form of this command to disable testing.
By default, health monitoring is enabled only for a few tests, and the device generates a syslog message when
a test fails.
Follow these steps to configure and enable the health-monitoring diagnostic tests:
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3 diagnostic monitor interval switch number test {name
| test-id | test-id-range | all} hh:mm:ss milliseconds day
Example:
Device(config)# diagnostic monitor interval switch
2 test 1 12:30:00 750 5
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
172
enable
configure terminal
diagnostic monitor interval switch number test {name | test-id | test-id-range | all} hh:mm:ss
milliseconds day
diagnostic monitor syslog
diagnostic monitor threshold switch number number test {name | test-id | test-id-range | all} failure
count count
diagnostic monitor switchnumber test {name | test-id | test-id-range | all}
end
show diagnostic { content | post | result | schedule | status | switch }
show running-config
copy running-config startup-config
Purpose
Enables privileged EXEC mode.
Enter your password, if prompted.
Enters global configuration mode.
Configures the health-monitoring interval of the specified
test.
The switch number keyword is supported only on stacking
switches.
When specifying a test, use one of these parameters:
Configuring Online Diagnostics