Cisco Catalyst 6500 Series Command Reference Manual page 128

standby mac-address
In an APPN network, an end node is typically configured with the MAC address of the adjacent network
node. Use the standby mac-address command in the routers to set the virtual MAC address to the value
that is used in the end nodes.
Examples This example shows how to configure HSRP group 1 with the virtual MAC address:
ssl-proxy (config-subif)# standby 1 mac-address 4000.1000.1060
ssl-proxy (config-subif)#
Related Commands show standby
standby version
Catalyst 6500 Series Switch SSL Services Module Command Reference
2-102
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
OL-9105-01