Show Interfaces Ssl-Proxy - Cisco Catalyst 6500 Series Command Reference Manual

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

show interfaces ssl-proxy

To display information about the configured subinterfaces, use the show interfaces ssl-proxy command.
Syntax Description subinterface-number
Defaults This command has no default settings.
Command Modes EXEC
Command History Release
SSL Services Module
Release 3.1(1)
Examples This example shows how to display information about the configured subinterfaces:
ssl-proxy# show ionterfaces 0.3
SSL-Proxy0.3 is up, line protocol is up
Hardware is STE interface, address is 0001.6445.c744 (bia 00e0.14c1.30e9)
Internet address is 10.10.0.16/8
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation 802.1Q Virtual LAN, Vlan ID
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters never
ssl-proxy#
Related Commands
policy tcp
OL-9105-01
show interfaces ssl-proxy 0.subinterface
Subinterface ID; valid values are from 0 to 4294967295.
Modification
Support for this command was introduced on the Catalyst 6500 series
SSL Services Module.
reliability 255/255, txload 1/255, rxload 1/255
3.
Catalyst 6500 Series Switch SSL Services Module Command Reference
show interfaces ssl-proxy
2-59