natpool
natpool
To define a pool of IP addresses, which the SSL Services Module uses for implementing the client NAT,
use the natpool command.
Syntax Description
nat-pool-name
start-ip-addr
end-ip-addr
netmask netmask
Defaults
This command has no default settings.
Command Modes
Context subcommand mode
Command History
Release
Cisco IOS Release
12.1(13)E and
SSL Services Module
Release 1.1(1)
SSL Services Module
Release 3.1(1)
Examples
This example shows how to define a pool of IP addresses:
ssl-proxy(config)# ssl-proxy context Example
ssl-proxy (config-context)# natpool NP2 207.59.10.01 207.59.10.08 netmask 255.0.0.0
ssl-proxy (config-context)#
Related Commands
show ssl-proxy natpool
Catalyst 6500 Series Switch SSL Services Module Command Reference
2-30
natpool nat-pool-name start_ip_addr end_ip_addr netmask netmask
NAT pool name.
First IP address in the pool.
Last IP address in the pool.
Specifies the netmask address.
Modification
Support for this command was introduced on the Catalyst 6500 series
switches.
The natpool command (entered in context subcommand mode) replaces
the ssl-proxy natpool command (entered in global subcommand mode).
Chapter 2
Commands for the Catalyst 6500 Series SSL Services Module
OL-9105-01