Cisco Catalyst 6500 Series Command Reference Manual page 136

standby redirects
The no standby redirects command is the same as the standby redirects disable command. We do not
recommend that you save the no form of this command to NVRAM. Because the command is enabled
by default, we recommend that you use the standby redirects disable command to disable the
functionality.
With the standby redirects command enabled, the real IP address of a router can be replaced with a
virtual IP address in the next-hop address or gateway field of the redirect packet. HSRP looks up the
next-hop IP address in its table of real IP addresses versus virtual IP addresses. If HSRP does not find a
match, the HSRP router allows the redirect packet to go out unchanged. The host HSRP router is
redirected to a router that is unknown, that is, a router with no active HSRP groups. You can specify the
no standby redirects unknown command to stop these redirects from being sent.
Examples
This example shows how to allow HSRP to filter ICMP redirect messages:
ssl-proxy (config-subif)# standby redirects
ssl-proxy (config-subif)#
This example shows how to change the HSRP router advertisement interval to 90 seconds and the
holddown timer to 270 seconds on interface Ethernet 0:
ssl-proxy (config-subif)# standby redirects timers 90 270
ssl-proxy (config-subif)#
Related Commands show standby
show standby redirect
Catalyst 6500 Series Switch SSL Services Module Command Reference
2-110
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
OL-9105-01