Interface Ssl-Proxy - Cisco Catalyst 6500 Series Command Reference Manual

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

interface ssl-proxy

To enter the subinterface configuration submode, use the interface ssl-proxy command. In interface
configuration submode, you can configure a subinterface for the SSL Services Module.
Note The ssl-proxy0 interface is enabled by default and should not be shut down or otherwise configured.
Syntax Description subinterface-number
Defaults
This command has no default settings.
Command Modes Global configuration
Command History Release
SSL Services Module
Release 3.1(1)
Usage Guidelines When you upgrade to SSL software release 3.x from SSL software release 2.x or 1.x, the VLAN
configuration is converted automatically to an subinterface configuration. For example, ssl-proxy vlan 3
is converted to interface ssl-proxy0.3.
The ssl-proxy0 interface is enabled by default and should not be shut down or otherwise configured.
Note
Table 2-1
Table 2-1 Subinterface Configuration Submode Command Descriptions
Syntax
default
description
encapsulation dot1q vlan_ID [native]
exit
ip address ipaddress subnet [secondary]
no
OL-9105-01
interface 0.subinterface-number
Subinterface ID; valid values are from 0 to 4294967295.
Modification
Support for this command was introduced on the Catalyst 6500 series
SSL Services Module.
This command replaces the ssl-proxy vlan command.
lists the commands that are available in subinterface configuration submode.
Description
Sets a command to its defaults.
Allows you to enter a description for the subinterface.
Sets the encapsulation type for the interface. Enter the native keyword to
make this a native VLAN.
Exits from the subinterface configuration submode.
Configures the subinterface with an IP address and a subnet mask. Enter the
secondary keywork to make this IP address a secondary address.
Negates a command or sets its defaults.
Catalyst 6500 Series Switch SSL Services Module Command Reference
interface ssl-proxy
2-27