Cisco Catalyst 6500 Series Command Reference Manual page 52

do
do
To execute EXEC-level commands from global configuration mode or other configuration modes or
submodes, use the do command.
Syntax Description command
Defaults
This command has no default settings.
Command Modes Global configuration or any other configuration mode or submode from which you are executing the
EXEC-level command.
Command History Release
Cisco IOS Release
12.1(13)E and
SSL Services Module
Release 1.1(1)
Usage Guidelines
Do not enter the do command in EXEC mode. Interruption of service may occur.
Caution
You cannot use the do command to execute the configure terminal command because entering the
configure terminal command changes the mode to configuration mode.
You cannot use the do command to execute the copy or write command in the global configuration or
any other configuration mode or submode.
Examples This example shows how to execute the EXEC-level show interfaces command from within global
configuration mode:
ssl-proxy(config)# do show interfaces serial 3/0
Serial3/0 is up, line protocol is up
Hardware is M8T-RS232
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
Last input never, output 1d17h, output hang never
Last clearing of "show interface" counters never
.
.
.
ssl-proxy(config)#
Catalyst 6500 Series Switch SSL Services Module Command Reference
2-26
do command
EXEC-level command to be executed.
Modification
Support for this command was introduced on the Catalyst 6500 series
switches.
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
OL-9105-01