Setup Mode - Graco PCF Instructions Manual

Setup Mode

Setup mode screens are divided into four sections: Sys-
tem setup, Advanced setup, Gateway setup, and Fluid
plate setup. While in Run mode, press
Setup mode. Press
Setup mode screens.
If the setup screens are password protected, a pass-
word entry screen will appear after pressing
password is defined in the Advanced setup screen. If the
password is set to 0000, the password is disabled.
Advanced Setup Screens
There are four Advanced setup screens, which enable
users to set units, adjust values, set formats, define USB
settings, and view software information for each compo-
nent. Press to scroll through the Advanced
setup screens. Once in the desired Advanced setup
screen, press to access the fields to make changes.
Press to exit edit mode.
NOTE: Users must be out of edit mode to scroll
through the Advanced setup screens.
Advanced Setup Screen 1
This screen enables users to set the language, date for-
mat, current date and time, password, and number of
minutes before the screen saver comes on. The time
does not automatically update for daylight savings time.
3A2098A
to enter
to navigate through the
. The
Appendix A - Advanced Display Module (ADM)
Advanced Setup Screen 2
This screen enables users to set the units of measure
for maintenance volume, maintenance mass, pressure,
and flow rate.
Advanced Setup Screen 3
This screen enables users to setup USB-related set-
tings. The Disable USB Log Errors option disables
recording events when the logs are at least 90% full.
Advanced Setup Screen 4
This screen displays the software part number and ver-
sion for the ADM, USB configuration, Gateway module,
and fluid plates.
91