Install Cable Assemblies - Graco PCF Instructions Manual

Install Cable Assemblies

1. Connect the CAN cable from the control center to
one fluid plate assembly.
2. For multiple fluid plate systems, use a CAN cable to
connect each fluid plate to one other fluid plate.
Repeat until all fluid plates are connected to one
other fluid plate.
NOTE: Use the connections on the CAN splitter on
the left side of each fluid plate to connect the fluid
plates together. There will be a CAN splitter on all
but one fluid plate.
F . 16: Cable Installation Diagram
IG
3A2098A
3. Use the automation interface cable to connect the
Gateway module to the automation controller.
Multiple Fluid Plate System Shown
1
2
2
3
2
Installation
25