System Setup; Overview - Graco PCF Instructions Manual

Hide thumbs Also See for PCF:

Table of Contents

System Setup

The PCF system compensates for temperature, flow, or

pressure fluctuations. However, if there is a hardware

change on the supply system or the dispense material is

changed, the PCF system must be set up again.

After material is loaded into the supply system, set up

the PCF system using the Setup screens. F

the major system setup steps. The following subsections

provide instructions to complete each setup step. Once

these steps are complete the module is ready for opera-

tion.

NOTE: See the Advanced Display Module (ADM)

section, page 15, and Appendix A - Advanced Dis-

play Module (ADM), page 89, for detailed operating

instructions for the display keypad and each screen.

. 18 shows

. 18

Begin System Setup

Configure System (page 29)

Configure Control Settings (page 30)

Configure Mode Settings (page 31)

Configure Delay Settings (page 32)

Configure Flow Meter

Settings (page 32)

Configure Pressure Loop

Settings (page 33)

Adjust Pressure Sensors (page 33)

Configure Errors (page 34)

Setup Maintenance

Schedule/Parameters (page 34)

Configure Gateway

Settings (page 35)

Setup Styles (page 35)

Configure Advanced

Settings (page 35)

End System Setup

3A2098A

Table of Contents