Fluid Plate Assembly Technical Data; Control Center Assembly Technical Data - Graco PCF Instructions Manual

Fluid Plate Assembly Technical Data

Mounting dimensions and parts breakdowns for the fluid plate assemblies are in the installation section of this man-
ual.
Regulator Manual
Weight - No Flow Meter
Weight - Helical
Fluid Port Inlet
Fluid Port Outlet
Maximum Fluid Working Pressure*
Air Supply
Maximum Air Working Pressure
Minimum Air Working Pressure
Fluid Operating Temperature
Minimum Flow Rate - Helical
*Maximum system pressure depends on dispense valve.
Air outlets, open and close to dispense valve
Electric Power Requirements
Power Supplied to Dispense Valve Solenoid(s)
Fluid Specifications
Ambient Air Temperature Range

Control Center Assembly Technical Data

100 - 240 Vac Assemblies
Part Numbers ---
Voltage 100-240 Vac
Phase 1
Frequency 50-60 Hz
Full Load Current 1.4 A
Fuse Rating 250 Vac, 2.5A T
3A2098A
Cartridge Regulator
308647
25.5 lbs (11.6 kg)
40 lbs (18 kg)
Helical: 3/4 in. npt(f)
1/2 in. npt(f)
See Models on page 4
1/4 in. npt(f)
100 psi (0.7 MPa, 7.0 bar)
60 psi (410 kPa, 4.1 bar)
Ambient 40° - 120°F (4° - 50°C)
Ambient 25 cc/min
5/32 in. (4 mm) tube fittings
24 Vdc or 100-240 Vac
24 Vdc
For use when dispensing fluids that meet at least one of
the following conditions for non-flammability:
• The fluid has a flash point above 140° F (60° C) and a
maximum organic solvent concentration of 20% by
weight, per ASTM Standard D93.
• The fluid does not sustain burning when tested per
ASTM Standard D4206 Sustained Burn Test.
40° to 120° (4° to 50° C)
Mastic Regulator
307517
33 lb (15 kg)
48 lb (22 kg)
3/4 in. npt(f)
3/4 in. npt(f)
See Models on page 4
1/4 in. npt(f)
100 psi (0.7 MPa, 7.0 bar)
60 psi (410 kPa, 4.1 bar)
Heated 40° - 400°F (4° - 204°C)
Ambient 40° - 120°F (4° - 50°C)
Heated 50 cc/min
Ambient 25 cc/min
24 Vdc Assembly
---
24 Vdc
---
---
4.0 A
125 Vac, 4A F
Technical Data
123