Configure Control Settings - Graco PCF Instructions Manual

System Setup

Configure Control Settings

Set the controls for the dispense source, how dispense
commands are sent, and job settings.
1. With the system in setup mode, navigate to Fluid
Plate x, screen 1 (Control Settings).
2. Press to access the fields to make changes.
F . 20
IG
3. Press to open the Dispense Trigger Source
drop-down list, and select Gateway, Command
Cable, or Combined. If Command Cable is selected,
users can enable the valves. Press
the selection.
4. If the dispense trigger source is set to Command
Cable, press to move to the Enable Valves field.
Press and
5. Press to move to the Command Value Source
field. Press to open the drop-down list, and
select Gateway, Command Cable, or Display. Press
to enter the value.
6. Press to move to the Job End Mode field. Press
to open the drop-down list, and select Timer or
Gateway. Press
30
to finalize
to enable valves.
to enter the value.
7. Press to move to the Job End Delay field. Enter
the desired delay time (in seconds). Press
enter the value.
8. Press to move to the Run Mode Bead Adjust
field. Press to open the drop-down list, and
select Enable or Disable. Press
value.
9. Press to exit edit mode.
10. If multiple fluid plates are installed, repeat this pro-
cedure for the other Fluid Plates.
to
to enter the
3A2098A