Installation; Before Installation; Overview - Graco PCF Instructions Manual

Installation

Installation

Before Installation

• Have all system and component documentation
available during installation.
• See component manuals for specific data on compo-
nent requirements. Data presented here applies to
the PCF assemblies only.
• Be sure all accessories are adequately sized and
pressure-rated to meet system requirements.
• Use the PCF control center only with the PCF fluid
plate assembly.
18

Overview

The basic steps to install a PCF system are shown
below. See the separate component manuals for
detailed information.
NOTICE
To avoid damaging the PCF system, use at least two
people to lift, move, or disconnect the system. The
system is too heavy for one person to lift or move.
Installation Steps
1. Mount control center, page 19.
2. Connect and ground control center, page 20.
3. Mount fluid plate assembly, page 21.
4. Ground fluid plate assembly, page 24.
5. Check ground continuity.
6. Connect fluid lines between fluid plate and applica-
tor. Connect fluid supply line and air supply to mod-
ule. See page 24.
7. Plumb air filter assembly near air supply drop site
that will be used for fluid plate assembly.
8. Connect other fluid and air lines to additional system
components as instructed in their manuals.
9. Install cable assemblies, page 25.
10. Install Gateway interface, page 26.
3A2098A