Adjust Drum Stops; System Setup (Pneumatic Control); System Setup; Control) - Graco SaniForce SDU Series Manual

Adjust Drum Drum Stops Stops
Adjust Adjust Drum Stops
NOTICE
NOTICE NOTICE
To prevent pinching or damaging the seal during
drum insertion, only inflate the seal when the top
lip of the ram plate is at, or below, the top edge
of the drum.
The drum stops are a cam which will allow adjustment
for different types of drums.
1. Loosen the bolt in each drum stop (H) and rotate
them away from the ram plate.
2. Raise the ram assembly.
3. Place an empty drum on the SDU baseplate.
4. Lower the ram assembly near the top of the drum.
5. Position the drum to properly align with the ram
plate.
3A5402J
6. Lower the ram assembly partially into the drum
and inflate the ram plate seal (if applicable).
7. Rotate each drum stop to contact the drum and
tighten the drum stop bolts.
8. Deflate the ram plate seal (if applicable), raise
the ram assembly, and remove the empty drum.

System Setup

Setup (Pneumatic (Pneumatic Control)
System System Setup (Pneumatic
1. Connect supply air.
2. Adjust air pressure settings for control functions.
3. Adjust drum stops for use with desired drums.
4. Connect outlet fittings and hoses.
5. Perform test drum unload. See
Start and Adjust the Pump, page
System System Setup System Setup (Electro Setup (Electro - - - pneumatic (Electro

Control)

Control) Control)
1. Apply power.
2. Connect supply air.
3. Adjust drum stops for use with desired drums.
4. Set SDU parameters.
System Configuration Screen, page
5. Define recipes. See
6. Connect outlet fittings and hoses.
7. Perform test drum unload.
Installation
Control)
Control)
20.
pneumatic pneumatic
See
47.
Recipe Screens, page 33.
17