Interlogix CDC4 Installation And Programming Manual page 92

Chapter 4: Menu reference
Note: CDC4 inputs are masked if they are not mapped to Advisor Advanced
input numbers.
Input no
Enter a number in the range 1 to 32. The mapped input number is an index into
the Advisor Advanced input numbering scheme. Thus, for the CDC4 with
address 1 on the Advisor Advanced panel bus 1, mapped input numbers 1 to 32
correspond to Advisor Advanced input numbers 17 to 48. See the "Input and
output mapping" section on page 66 for information on Advisor Advanced input
mapping.
Input type
Specify the input type for the input mapping. The input types are:
•
Not used (reports inactive): The input always reports as inactive.
•
Forced: The input is a logical input associated with a door and is active when
the door has a Forced Door alarm (from the Door input 1 being active) or
there is a tamper condition. Specify the door in the Door field.
•
RTE: The input is a logical input associated with a door and is active when
the door is in RTE condition (i.e. the door RTE input is active) or there is a
tamper condition. Specify the door in the Door field.
•
DOTL: The input is a logical input associated with a door and is active when
the door has a Door Open Too Long (DOTL) alarm (from the door's Door
input 1 being active). Specify the door in the Door field.
•
Shunted Pass through: The input is a physical input which is passed through
to the Advisor Advanced panel if the associated door is not shunting. Specify
the door in the Door field. The input location must be specified in the Input
field.
•
Direct pass through: The input is a physical input which is passed directly
through to the Advisor Advanced panel. This type of input cannot be assigned
to a door. The input location must be specified in the Input field.
Door
If the Input type field is one of Forced, RTE, DOTL, or Shunted pass through,
then you must specify a door to be associated with the input mapping.
Enter the door number to associate the door with the input mapping.
86 CDC4 Door Controller Installation and Programming Manual