Interlogix CDC4 Installation And Programming Manual page 53

Figure 22: Extended mode
(5)
ATS
(1) Configuration software
(2) Management software
(3) Ethernet
(4) CDC4 Door Controller
(5) Advisor Advanced control panel
(6) RS485 data bus
In this mode, management software downloads users, door groups, etc. directly
to CDC4, allowing CDC4 to utilise its maximum capacities, as shown in Table 6
on page 45. CDC4 retains its own database of users, door groups etc. from the
Advisor Advanced panel.
The number of users that can exercise alarm control from CDC4 is limited by the
user capacity of the Advisor Advanced panel. See the "Alarm control" section on
page 59 for more information.
Access events are sent directly via IP to management software, while alarms and
CDC4 status are sent to the Advisor Advanced panel.
Note that hardware configuration can only be made by the configuration software
connected to the Advisor Advanced control panel.
Notes
•
CDC4 will still be fully functional if it is disconnected from management
software.
•
Inputs will only register alarms in the Advisor Advanced panel if they are
mapped to Advisor Advanced inputs. See the "Input and output mapping"
section on page 66 for information on Advisor Advanced input mapping.
CDC4 Door Controller Installation and Programming Manual
(1)
ATS8500
(3)
(6)
(A) Hardware/Door configuration
(B) User credentials and user groups
(C) Intrusion events
(D) Access events
Chapter 2: System functions
(2)
ATS8600
(3) (3)
(A)
(B)
(C)
(D)
(4)
CDC4
configuration
47