Omron CK3W-GC 00 Series Hardware User Manual page 38

1 Introduction to Motion Controllers
No. Step
7 Construction of Settings of the
the EtherNet/IP originator device
*2
network
Settings of the
connection
8 Preparation for Creation of a new
setting the Mo- project
tion Controller
Initialization of the
Controller
9 Settings of the Motor settings
Motion Control-
ler operation
Programming
10 Transferring project data and check-
ing the operation
*1. When you are using CK3M-CPU101, no setting is required.
*2. Perform settings only when EtherNet/IP is used.
1-6
Description
Configure the originator device settings. For details, refer to the manual for
Configure the connection settings.
Connect the computer with the Support
Software installed to the Motion Con-
troller, and then start Power PMAC IDE
and create a new project.
Use Power PMAC IDE to initialize the
Motion Controller.
Use Power PMAC IDE to set the motor
operations for the Motion Controller.
Create user programs on Power PMAC
IDE.
Transfer the created project data and
check that operations work as expect-
ed.
CK3M-series Programmable Multi-Axis Controller User's Manual Hardware (O036)
Reference
the originator device.
Refer to the NJ/NX-series CPU
Unit Built-in EtherNet/IP Port
User's Manual (Cat. No. W506)
when the NJ/NX Series is used.
Refer to the Power PMAC IDE
User Manual (Cat. No. O016) for
details.
Refer to the Power PMAC IDE
User Manual (Cat. No. O016) for
details.
Refer to the Power PMAC IDE
User Manual (Cat. No. O016) for
details.
Refer to the Power PMAC IDE
User Manual (Cat. No. O016) for
details.
Refer to the Power PMAC User's
Manual (Cat. No. O014) and the
Power PMAC Software Reference
Manual (Cat. No. O015) for details.
Refer to the Power PMAC IDE
User Manual (Cat. No. O016) for
details.