Omron CK3W-GC 00 Series Hardware User Manual page 179

Manufactur-
er
Phoenix Con-
tact
Weidmüller
 Using Twisted or Solid Wires
Wire type
Solid wire
Twisted wire
Required Tools
Use a flat-blade screwdriver to remove wires.
The recommended screw driver is as follows.
Model
SZF 0-0,4X2,5 Phoenix Contact
Connecting Ferrules
Insert the ferrule straight into the terminal hole.
It is not necessary to press a flat-blade screwdriver into the release hole.
After you make a connection, make sure that the ferrule is securely connected to the terminal block.
Connecting Twisted Wires/Solid Wires
Use the following procedure to connect the twisted wires or solid wires to the terminal block.
1
Press a flat-blade screwdriver straight into the release hole.
If you press in the screwdriver correctly, you will feel the spring in the release hole, and the
screw driver will begin to incline.
CK3M-series Programmable Multi-Axis Controller User's Manual Hardware (O036)
Applicable wire
Ferrule model
2
(mm
AI0,25-8 0.25 (#24)
AI0,5-8 0.5 (#20)
AI0,75-8 0.75 (#18)
H0.25/12 0.25 (#24)
H0.34/12 0.34 (#22)
H0.5/14 0.5 (#20)
H0.75/14 0.75 (#18)
Conductor cross-sectional area
2
0.2 to 1.5 mm
Manufacturer
Ferrule
(applicable wire size given in parentheses)
(AWG))
Phoenix Contact
CRIMPFOX 6 (0.25 to 6 mm
Weidmüller
PZ6 Roto (0.14 to 6 mm
Conductor length
(stripping length)
8 mm
5 Wiring
Crimping Tool
2
, AWG24 to 10)
2
, AWG26 to 10)
5
5-15