Omron CK3W-GC 00 Series Hardware User Manual page 180

5 Wiring
2
Leave the flat-blade screwdriver pressed into the release hole and insert the twisted wire or the
solid wire into the terminal hole.
Insert the twisted wire or the solid wire until the stripped portion is no longer visible to prevent
shorting.
3
Remove the flat-blade screwdriver from the release hole.
After you make a connection, make sure that the twisted wire or the solid wire is securely connected to
the terminal block.
Precautions for Safe Use
• Make sure that all wiring is correct.
• Do not bend the cable forcibly. Doing so may break the cable.
Removing Wires
Use the following procedure to remove the wires from the terminal block.
The removal method is the same for ferrules, twisted wires, and solid wires.
1
Press a flat-blade screwdriver straight into the release hole.
If you press in the screwdriver correctly, you will feel the spring in the release hole, and the
screw driver will begin to incline.
5-16
Release hole
Twisted wire/Solid wire
2
3
CK3M-series Programmable Multi-Axis Controller User's Manual Hardware (O036)
1
Flat-blade screwdriver