Table of Contents
Advertisement
Additional scanner and printer setup
5
Push the card firmly into place as shown in the illustration.
Warning—Potential Damage: Improper installation of the card may cause damage to the card and to the
system board.
Note: The entire length of the connector on the card must touch and be flush against the system board.
6
Reattach the system board shield.
Installing a memory card
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the scanner, then turn the scanner off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the scanner, then turn them off as well,
and unplug any cables going into the scanner.
Warning—Potential Damage: System board electronic components are easily damaged by static electricity. Touch
something metal on the scanner before touching any system board electronic components or connectors.
An optional memory card can be purchased separately and attached to the system board.
1
Access the system board.
For more information, see
Note: This task requires a flathead screwdriver.
2
Unpack the memory card.
Note: Avoid touching the connection points along the edge of the card.
"Accessing the system board" on page
34.
47
Advertisement
Table of Contents
