Table of Contents
Advertisement
Chapter 3 Basic Operations — Operating with the remote control
Using the automatic setup function
The image position and the signal level can be automatically adjusted when HDMI/DVI-D/DisplayPort signal is
input.
It is recommended to input an image with bright white borders at the edges and high-contrast black and white
characters when executing the automatic setup. Avoid using images that include halftones or gradation, such as
photographs and computer graphics.
button
1)
Press the <AUTO SETUP> button.
f [COMPLETE] is displayed when it has completed without any problem.
Note
f It is necessary to install the optional Interface Board equipped with the corresponding input on the slot to input the DisplayPort signal directly
without passing through the <DIGITAL LINK> terminal.
f If an image with blurred edges or a dark image is input, [INCOMPLETE] may appear or adjustment may not be performed properly even
when [COMPLETE] appears. In such a case, adjust the following settings.
g [POSITION] menu → [SHIFT] (x page 101)
f The items to be automatically adjusted when the automatic setup is executed can be set in the [DISPLAY OPTION] menu → [AUTO SETUP]
(x page 117).
f The [DISPLAY OPTION] menu → [AUTO SETUP] → [SIGNAL LEVEL ADJUST] does not operate in following cases.
g When 1080/120p image is displayed
g When 4K video signal is input while the [POSITION] menu → [ASPECT] is set to [THROUGH]
f Automatic adjustment may not be possible depending on the computer model.
f Image may be disrupted for a few seconds during execution of the automatic setup, but it is not a malfunction.
f Adjustment is required for each input signal.
f Automatic setup can be canceled by pressing the <MENU> button while the automatic setup is being executed.
f Even if a signal possible to perform the automatic setup is being input, it may not be able to adjust correctly if the automatic setup function is
executed while the moving image is being input. [INCOMPLETE] may be displayed, or the adjustment may not be completed correctly even
if [COMPLETE] is displayed.
Using the function button
By assigning the following functions to the <FUNCTION> button, it can be used as a simplified shortcut button.
[SUB MEMORY], [SYSTEM SELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE], [WAVEFORM MONITOR],
[ASPECT], [PROJECTION METHOD], [GEOMETRY], [OSD POSITION]
button
1)
Press the <FUNCTION> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 162).
Displaying internal test pattern
The projector has nine types of internal test patterns to check the condition of the projector. To display test
patterns, perform the following steps.
button
1)
Press the <TEST PATTERN> button.
2)
Press qw to select the test pattern.
Note
f Test patterns can also be displayed using the menu operation. Refer to "[TEST PATTERN] menu" (x page 169) for details.
f Settings of position, size, and other factors will not be reflected in test patterns. Make sure to display the input signal before performing
various adjustments.
84 - ENGLISH
Advertisement
Table of Contents
