Table of Contents
Advertisement
For <SDI IN> terminal
Digital VCR for commercial use
Note
f Setting of the [DISPLAY OPTION] menu → [SDI IN] may be necessary depending on the connected external device.
f Use a connection cable of 5C-FB or higher (such as 5C-FB or 7C-FB) or Belden 1694A or higher to properly transmit images. Use a
connection cable with length of 100 m (328'1") or less.
f An error in signal detection may occur when an unsteady signal is connected. In such case, set the [DISPLAY OPTION] menu → [SDI IN] to
the content corresponding to the input signal.
For <HDMI IN 1>/<HDMI IN 2> terminals of the Interface Board
This is an example when the optional Interface Board for HDMI 2 input (Model No.: ET-MDNHM10) is installed in
the slot.
Blu-ray disc player
Note
f For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. However, when the following 4K video signal
exceeding the supported transmission speed of the HDMI High Speed cable is to be input, use the HDMI cable supporting the high speed
transmission of 18 Gbps such as the one with Premium HDMI cable authentication.
g A video signal with high specification color depth and gradation such as 3840 x 2160/60p 4:2:2/36-bit or 3840 x 2160/60p 4:4:4/24-bit
Images may be disrupted or may not be projected when a video signal exceeding the supported transmission speed of the HDMI cable is
input.
f Setting the [DISPLAY OPTION] menu → [SLOT IN] is required depending on the connected external device or the input signal.
f The <HDMI IN 1>/<HDMI IN 2> terminals can be connected to the external device with a DVI-D terminal by using the HDMI/DVI conversion
cable. However, this may not function properly for some external devices, and image may not be projected.
f The projector does not support VIERA Link (HDMI) and HDMI CEC (Consumer Electronics Control).
56 - ENGLISH
Chapter 2 Getting Started — Connecting
HD-SDI signal or 3G-SDI signal
Advertisement
Table of Contents
