Table of Contents
Advertisement
5)
Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f Proceed to Step 10) when [DEFAULT] is selected.
6)
Press the <ENTER> button.
f The [RESOLUTION] screen is displayed.
7)
Press asqw to select [RESOLUTION].
f Select [1024x768p], [1280x720p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p], [1440x900p],
[1600x900p], [1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], [1920x1200p], or [3840x2400p].
8)
Press the <ENTER> button.
f The [VERTICAL SCAN FREQUENCY] screen is displayed.
9)
Press qw to switch [VERTICAL SCAN FREQUENCY].
f The setting is fixed to [30Hz] when [3840x2400p] is selected for [RESOLUTION].
f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for [RESOLUTION].
f Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].
f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].
g [3840x2400p], [1920x1080p], [1920x1080i]
10) Press the <ENTER> button.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] of [EDID STATUS].
f Setting of the resolution and the vertical scanning frequency may be necessary on the computer or video device in use.
f The computer, video device, or projector in use may require the power to be turned off and on again after configuring settings.
f The output with the set resolution or vertical scanning frequency may not be possible depending on the computer or video device in use.
[SLOT IN]
Set this item in accordance with the signal input to the input terminal of the installed Interface Board when the
optional Interface Board is installed in the slot.
The content that can be set varies depending on the installed Interface Board. It cannot be set if the Interface
Board is not installed in the slot.
When the optional Interface Board for HDMI 2 input (Model No.: ET-MDNHM10) is installed
Setting [SIGNAL LEVEL] in [SLOT IN] (HDMI input)
1)
Press as to select [SLOT IN].
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3)
Press as to select [SIGNAL LEVEL] of the corresponding input.
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[64-940]
[0-1023]
Chapter 4 Settings — [DISPLAY OPTION] menu
Standard setting.
Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items as EDID.
Automatically sets the signal level.
Select this item when the signal output from the HDMI terminal of the external device (such as a Blu-
ray disc player) is input to the <HDMI IN 1> terminal or the <HDMI IN 2> terminal.
Select this item when the signal output from the DVI-D terminal of the external device (such as a
computer) is input to the <HDMI IN 1> terminal or the <HDMI IN 2> terminal using a conversion cable,
etc.
Select this item also when the signal output from the HDMI terminal of a computer, etc., is input to the
<HDMI IN 1> terminal or the <HDMI IN 2> terminal.
ENGLISH - 125
Advertisement
Table of Contents
