Table of Contents
Advertisement
2)
Press as to select [DATA CLONING].
3)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
4)
Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
5)
Press as to select [USB MEMORY].
6)
Press the <ENTER> button.
f The [SELECT COPY TYPE] screen is displayed.
7)
Press as to select [PROJECTOR -> USB MEMORY].
8)
Press the <ENTER> button.
f The confirmation screen is displayed.
9)
Press qw to select [OK], and press the <ENTER> button.
f Copying of data to the USB memory is started.
Once the copying of data is completed, [Data copy finished.] is displayed.
10) Once the copying of the data is completed, disconnect the USB memory from the <USB> terminal.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f For the USB memory that can be used with the projector and handling of the memory, refer to "Using the USB memory" (x page 82).
f An error message is displayed when saving or reading data to/from the USB memory has failed.
Copying data in the USB memory to the projector
1)
Insert the USB memory into the <USB> terminal.
2)
Press as to select [DATA CLONING].
3)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
4)
Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
5)
Press as to select [USB MEMORY].
6)
Press the <ENTER> button.
f The [SELECT COPY TYPE] screen is displayed.
7)
Press as to select [USB MEMORY -> PROJECTOR].
8)
Press the <ENTER> button.
f The confirmation screen is displayed.
9)
Press qw to select [OK], and press the <ENTER> button.
f The projector automatically enters standby state and starts copying data from the USB memory to the
projector.
10) Once the copying of the data is completed, disconnect the USB memory from the <USB> terminal.
11) Turn on the power of the projector.
f The copied content is reflected to the projector.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f The light source indicator <LIGHT1>/<LIGHT2> and the temperature indicator <TEMP> of the copy destination projector blink while copying
the data. Confirm the blinking of the indicators stops, and then turn on the power supply.
Chapter 5 Operations — Using the data cloning function
ENGLISH - 213
Advertisement
Table of Contents
