Table of Contents
Advertisement
f The shutter function of the projector with [MODE] set to [SLAVE] can be operated individually. At that time, the shutter operation will follow
the setting of the [DISPLAY OPTION] menu → [SHUTTER SETTING] set in that projector.
[FREEZE]
Stop the projected image temporarily regardless of the playback of the external device.
1)
Press as to select [FREEZE].
2)
Press the <ENTER> button.
f Press the <MENU> button to release.
Note
f [FREEZE] is displayed on the screen when video is paused.
[WAVEFORM MONITOR]
Use the input signals from a connected external device to display in a waveform. Check whether video output
(luminance) signal level is within the recommended range for the projector and adjust.
1)
Press as to select [WAVEFORM MONITOR].
2)
Press qw to switch the item.
[OFF]
[ON]
3)
Press the <MENU> button two times to clear.
4)
Press as to select any horizontal line.
5)
Press the <ENTER> button to switch the Select line to either luminance, red, green, or blue.
f Line selection items switch each time the <ENTER> is pressed only when the waveform monitor is
displayed.
"Select line (luminance)"
"Select line (red)"
"Select line (green)"
"Select line (blue)"
Note
f Setting is also available from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON].
f The waveform monitor is not displayed when on-screen display is hidden (off).
Adjusting the waveform
Project the luminance adjustment signal of a commercial test disk (0 % (0 IRE or 7.5 IRE) – 100 % (100 IRE)) and
adjust.
1)
Select "Select line (luminance)" on the waveform monitor.
2)
Adjust black level.
f Adjust the black level 0 % of the video signal to the 0 % position of the waveform monitor using the
[PICTURE] menu → [BRIGHTNESS].
Chapter 4 Settings — [DISPLAY OPTION] menu
Does not display the waveform monitor.
Displays the waveform monitor.
Displayed in white waveform.
Displayed in red waveform.
Displayed in green waveform.
Displayed in blue waveform.
Image position
Image displayable area
ENGLISH - 139
Advertisement
Table of Contents
